adn-c series 3-phase 120-960 watts total power: 120-960 watts input voltage: 380-480 vac # outputs: single special features ? slim form factor ? five year warranty ? high effciency up to 94% ? full power at 60 c ? power boost? ? industrial grade design ? metal case ? mtbf > 500,000h ? adjustable output ? overvoltage protection with auto recovery ? continuous short circuit and overload protection ? new visual diagnostic led ? three status leds ? input ? output ? alarm ? dc ok relay ? parallel operation capability ? screw terminal connections ? rohs compliant ? no tools required for mounting safety ? ul508, culus listed ? ul 60950-1, curus 2 nd edition ? iec60950-1 2 nd edition ? class i, div 2 hazardous locations ? ip20 ? ce electrical specifcations input nominal voltage 380 - 480 vac ac input range 320 - 540 vac dc input range 450 - 760 vdc for adn5, adn10 & adn20 frequency 50 - 60 hz effciency up to 94% pfc active power factor correction for adn20 & adn40; meet en61000-3-2 class a phase input adn5 and adn10 will operate with single phase input at 100% load derate to 75% and 50% for adn20 and adn40 respectively under loss of 1 phase; units will shut down if thermal threshold is exceeded under this condition output nominal voltage 24 v (24.0 - 28.0 vdc adj.) hold-up time > 20 ms for adn5, adn10 & adn20; > 15 ms for adn40 voltage regulation < 2% overall ripple < 100 mvpp current limit powerboost? peak current 2x nominal current for < 2 sec for adn5 & adn10; 1.5x nominal current for 4 seconds minimum while holding voltage > 20 vdc for adn20 & adn40 parallel operation single or parallel operation selectable via front switch. for redundant operation use of external diode module is preferred; adn40 uses active paralleling power back immunity < 35 v overvoltage protection > 30.5 vdc, but < 33 vdc, auto recovery data sheet power
adn-c series 3-phase data sheet general specifcations emc emissions en61000-6-3:2001, class b en55011, en55022 radiated and conducted including annex. a, en61000-3-2 emc immunity en61000-6-1:2001, en61000-6-2:2001, en61000-4-2 level 4, en61000-4-3 level 3, en61000-4-6 level 3, en61000-4-4 level 4 input and level 3 output. en61000-4-5 isolation class 4, en61000-4-11, semi f47 sag immunity warranty 5 years general protection safety protected against continuous short-circuit, overload, open-circuit. protection class 1 (iec536), degree of protection ip20 (iec 60529) safe low voltage: selv (acc. en60950) status indicators visual: 3 status leds (input, output, alarm) relay: ssr or dry relay contact, signal octive when vout = 18.5 vdc + 5% led diagnostics led ok loss of ac low ac no dc high load overload hot too hot input green --- yellow green green green green green output green --- green --- yellow yellow green --- alarm --- --- --- red yellow red yellow yellow environmental specifcations storage/shipment -40 c to + 85 c operation (convection) full load -25 c to + 60 c derate to 50% load at +70 c up to 50% load permissable with horizontal or on top mounting orientation humidity < 90% rh, non-condensingl iec 60068-2-2, 68-2-3 other features fusing input externally fused; output not fused, output is capable of providing high currents (powerboost) for motor load startup mounting orientation standard: vertical, optional: horizontal or on top simple snap-on to din ts35/7.5 or ts35/15 rail system ventilation normal convection, no fan required cooling spacing adn5: 15 mm in front, 25 mm above and below adn10: 15 mm in front, 25 mm above and below adn20: 25 mm in front, left and right; 70 mm above and below adn40: 15 mm in front, 70 mm above and below, 25 mm left and rightt connections input: screw terminals, connector size range: 16-10 awg (1.5-6 mm 2 ) for solid conductors output: connector size range: 16-10 awg (1.5-6 mm 2 ) for adn5, adn10 and adn20 solid conductors; 6-7 awg for adn40
adn-c series 3-phase data sheet adn-c series 3-phase ds 03aug2015 ordering information model number power input voltage weight current effciency case type mtbf adn5-24-3pm-c 120 w 320 - 540 vac 450 - 760 vdc 1.15 lbs (520 g) 5 a @ 24 vdc 85.0% metal > 500,000 hours nominal voltage, full load, tamb=25 o c adn10-24-3pm-c 240 w 1.54 lbs (700 g) 10 a @ 24 vdc 91.2% ADN20-24-3PM-C 480 w 2.8 lbs (1300 g) 20 a @ 24 vdc 93.0% adn40-24-3pm-c 960 w 320 - 540 vac 5.3 lbs (2400 g) 40 a @ 24 vdc 94.0% dimensions height width depth adn5-24-3pm-c 4.85 in (123 mm) 1.97 in (50 mm) 4.36 (111 mm) adn10-24-3pm-c 4.85 in (123 mm) 2.36 in (60 mm) 4.36 (111 mm) ADN20-24-3PM-C 4.85 in (123 mm) 3.34 in (85 mm) 4.68 (119 mm) adn40-24-3pm-c 4.85 in (123 mm) 7.09 in (180 mm) 4.85 in (123 mm) mechanical drawing 380 - 480 v3; 3w + pe 50/60 hz 0.9 a / phase us listed ADN20-24-3PM-C parallel single c l u l2 l1 24 vd c/ 20 a + + - - ok w d h input alarm output 24 - 28 vd c l3 w d h l1 l2 + l3 + - - 24- 28v o k o v e r l o a d f u s e m o d e c o n t i n u o u s m o d e 3ph 380/500 vac 1.7/1.5a/phase 50/60 hz input : s i n g l e u s e p a r a l l e l u s e r e s e t f u s e m o d e us listed u c l adn40-24-3pm-c 0 v u q v u 7 % $ " & m f d u s p o j d b m m z 1 s p u f d u f e worldwide offices americas 2900 s.diablo way tempe, az 85282 usa +1 888 412 7832 europe (uk) waterfront business park merry hill, dudley west midlands, dy5 1lx united kingdom +44 (0) 1384 842 211 asia (hk) 14/f, lu plaza 2 wing yip street kwun tong, kowloon hong kong +852 2176 3333 for more information: www.artesyn.com/power for support: productsupport.ep@artesyn.com while every precaution has been taken to ensure accuracy and completeness in this literature, artesyn embedded technologies assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions. artesyn embedded technologies, artesyn and the artesyn embedded technologies logo are trademarks and service marks of artesyn embedded technologies, inc. all other names and logos referred to are trade names, trademarks, or registered trademarks of their respective owners. ? 2015 artesyn embedded technologies, inc. www.artesyn.com
|
